User Manual

310-2200 EZT

Figure 10. Motor Shaft

Refer to Figure 10.

Disassembly

1. Remove the control arm and bypass arm. See

page 15.

2. Drain the oil from the transaxle. See page 9.

3. Remove the side housing. See page 17.

4. Remove the reduction gears. See page 18.

5. Remove flat washer (36), motor shaft and pin-

ion gear (39 & 38) and flat washer (40).

Inspection

1. Inspect the motor shaft (39), pinnion gear (38)

and flat washers (36 & 40) for wear or dam-

age.

Assembly

1. Insert the motor shaft (39) with the pinnion

gear (38) and flat washers (36 & 40) into the

center section (57).

2. Install the reduction gears. See page 18.

3. Install the side housing. Refer to page 17.

4. Install new seals. Refer to page 16.

5. Fill the transaxle with oil. See page 9.

6. Install the bypass arm and control arm. See

page 15.

MOTOR SHAFT

www.mymowerparts.com

Hydro Gear Parts or New Units Call 606-678-9623 or 606-561-4983