User Manual

310-2200 EZT
®
9
FLUID CHANGE PROCEDURE
This transaxle is factory filled, sealed and does
not require oil maintenance. However, in the
event of oil contamination or degradation, oil
addition or change may alleviate certain perfor-
mance problems.
1. Remove the transaxle from the vehicle.
2. Clean the oil fill port area of any debris.
3. Remove the oil fill port fitting.
4. Position the transaxle so the oil will drain
completely out of the housing.
5. Fill the transaxle at the oil fill port according
to Figure 4.
6. Install the oil fill port fitting.
7. Purging will be required. Refer to the purg-
ing procedures on Page 10.
8. Recheck the fluid level once the unit has been
operated for approximately 1 minute.
Table 4. Fluid Volumes for the 310-2200 EZT
®
Fluid Description
20W50 engine oil
Volume
54.1 fl.oz. (1600 ml) to 57.5 fl.oz. (1700 ml)
FLUID CHANGE
Figure 4. Fluid Level and Fill Port
www.mymowerparts.com
Hydro Gear Parts or New Units Call 606-678-9623 or 606-561-4983