Operation Manual

25
Troubleshooting
If you have any further questions, please contact your authorised dealer on site.
All information, diagrams and specifications in these operating instructions are based on the latest product information
at the time of going to press. We reserve the right to make changes without prior notice.
Engine has no power or stops during cutting
Cause Procedure
Cutting head entangled with grass Stop the engine and clean the cutting attachment.
Dirty air filter Clean or replace air filter.
Old or incorrectly mixed fuel Empty the tank/fill with fresh fuel mixture.
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel.
Cutting head does release line
Cause Procedure
Cutting head entangled with grass Stop the engine and clean the cutting attachment.
No line in the cutting head Wind up new line.
Coil jammed Replace coil.
Cutting head dirty Clean coil and coil housing.
Line fused together Pull apart, take out the fused part and wind up the line
again.
Line twisted when wound up Pull apart and wind up the line again.
Not enough line released Tap the bump head and pull out the line until 10 cm of line
is outside the cutting attachment.