Operation Manual

24
Maintenance and repair
Long-term storage
If the unit is to be stored for a prolonged period, proceed
as follows:
1. Drain all the fuel out of the tank and pour into a container
with the same two-stroke mixture. Do not use fuel which
has been stored for longer than 30 days.
2. Start the engine and leave running until it stops.
This ensures that there is no fuel left in the carburettor.
3. Leave the engine to cool down. Take out the spark plug
and pour a high-quality engine oil or two-stroke oil into
the cylinder. Slowly pull the starter rope to distribute
the oil. Reinstall the spark plug.
Note: Before starting the lawn trimmer after storage, take out
the spark plug and pour all the oil out of the cylinder.
4. Thoroughly clean the unit and check for loose and
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts and bolts. The unit can now
be stored.
5. Store the unit locked away or high up to prevent
unauthorised use and damage. Keep the unit away
from children.
Transportation
 Before transporting the unit, leave it to cool down.
 Empty the fuel tank before transporting the unit.
Filler cap must be closed tightly.
 Secure the unit to prevent it from shifting during
transportation.
Warranty
The warranty regulations issued by our company or the
importer are valid in all countries. We shall repair any faults
on your unit free of charge in accordance with the warranty,
provided the fault was due to defective materials or manu-
facturing. If claiming under the warranty, please contact your
seller or your nearest branch.
Troubleshooting
Engine does not start
Cause Procedure
Ignition switch set to OFF Set switch to ON.
Fuel tank empty Fill fuel tank.
Intake pump not depressed adequately
Slowly and fully depress the intake pump 10 times
Engine flooded On appliances with a choke lever:
Implement the starting process with the choke lever
in the operating position.
On appliances without a choke lever:
Press the throttle and pull the starter cable.
Old or incorrectly mixed fuel Empty the tank/fill with fresh fuel mixture.
Dirty spark plug Replace or clean spark plug.
Engine does not run constanly at no load
Cause Procedure
Air filter blocked Clean or replace air filter.
Old or incorrectly mixed fuel Empty the tank/fill with fresh fuel mixture.
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel.
Engine does not accelerate
Cause Procedure
Old or incorrectly mixed fuel Empty the tank/fill with fresh fuel mixture.
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel.