Technical data

UPS MTD-XL
Operation
MTD series
61
7.1.4 Configuration of the UPS outputs
The UPS outputs are divided into two segment groups (LS1 and LS2).
1 UPS output LS1
2 UPS output LS2
Fig. 7-1 - 1 Segment groups - UPS output
You can activate or deactivate these segment groups individually.
To configure the segment groups, follow these steps:
 Press the "Enter" button for 3 seconds. The UPS switches into settings
mode.
 Select either "LS1" or "LS2" with the "Select" button.
 Press the "Enter" button for one second. The setpoint starts blinking.
 You can now activate or deactivate the individual segment group with the
"Select" button.
Please also see the table in chapter 7.1.2 UPS settings.
 Press the "Enter" button for three seconds or the "ON / OFF button" for 0.5
seconds to exit the settings menu.