Technical data

6.) Without moving the fitting, slide the Under-Clamp onto the base of the fitting.
7.) Make sure the fitting is centered in the Under-Clamp and then pivot the handle
into the secured position.
8.) Attach processor leads to the fitting and proceed with fusion as described for
standard joining. (If using a Bar-Code Processor see “Scanning Instructions” page
8)
IMPORTANT NOTE:
Proper installation of an electrofusion side-wall fitting requires the fitting to remain
secured in the clamp until the clamping time shown on the fitting label has been
completed! Outlets may be prepared prior to the Tapping Tee installation or at least
10 minutes after the Tapping Tee has been fused to the pipe.
Page 16
5.) Remove the fitting from the bag and place it on the area to be fused