Technical data

Re-Fusion of Electrofusion Fittings
Central Plastics electrofusion fittings can be re-fused only in the event of an input
power interruption, i.e. fusion leads were detached during fusion, generator runs out
of gas, processor malfunction, or other circumstance that results in processor input
power interruption.
The recommended procedure for re-fusing fittings is:
Fitting should remain in clamped position and be allowed to cool to ambient tem-
perature. The fitting should be reconnected to the processor and fused for the
entire fusion time. This re-fusion procedure should be used for fusions that termi-
nated due to input power reasons only.
Fittings that fault for any other reason should be cut out and replaced.
Page 10