Technical data

Note: Barcode Scanning Instructions
Be sure the processor is ready and the display is reading “Read Data”. It is critical
that the tip of the barcode reader be touching the barcode label. While holding the
reader at a 15 to 30 degree angle start the scan beginning in the white area on one
side of the label and move the reader evenly across the barcode into the white area
on the opposite side. Move the reader in a smooth quick motion, without stopping,
all the way across the label. The label can be read in either direction, front to back
or back to front. The processor should make an audible signal when the barcode
has been accepted.
Most difficulties experienced in barcode scanning are simple problems involving
technique. Ensure that the display reads “Read Data” before attempting to scan a
barcode label. Make sure the tip light is illuminated on the reader. If not, check
cable connections. Be sure the reader tip is clean and free from dirt and debris.
Move the reader pen across the barcode from white area to white area without
stopping.
Page 8