Manual

Triangle
Metal Tab
Left
Left Bracket
He)( Lock Nut
"Z" Fitting
Figure 4
Secure with hex bolt, spacer, and hex lock nut. Do
not overtighten this bolt as it will prevent the control
from automatically returning to their upright
position.
Repeat process for the right side Traction Control.
Lay handle assembly behind snow thrower.
See Figure 5.
Insert a hex bolt 3/4" long and lock washer through
the lower hole on the bottom of the handle.
Hold the handle assembly up to the bottom of the
snow thrower frame and thread the hex bolt intothe
lower hole in snow thrower frame. Do not tighten at
this time. See Figure 5.
Repeat process on the other side.
Hex Bolt__
Lock Washer
Figure 5
Raise the handle assembly into the upright position
and align the top holes in the handle with the top
holes in the snow thrower frame. Attach using 2"
long hex bolts, lock washers and saddles. (Curve in
saddle must match the curve in the handle.)
See Figure 6.
Tighten all hardware used to attach the handle
assembly to the snow thrower frame.
Saddle.
Cable
Guide
Washers Hex
Bolt
Figure 6
AttachingShiftRod(HardwareD)
Place the shift lever in the fastest forward speed
position.