Manual

SECTION2: CONTENTSOFHARDWAREPACK
A_ ATTACHING THE HANDLES Lock Washers
736-0!19(4)
Hex Bolts _
710-3259 (2) /'('_'_ (F _
III!IIItH]IIII]I!!_
Lay out the hardware according to the illustration below for identification purposes. Part numbers are shown in
}arentheses. (Hardware pack may contain extra items which are not used on your unit.)
_ ATTACHINGHANDLE PANEL
Carriage Bolts
ATTACHING CHUTE DIRECTIONAL CONTROL
Cupped Washer Eyebolt (Not Shown)
736-0242 747.0697
O_ ATTACHING CLUTCH CABLES AND SHIFT ROD
Z Fitting Hex Nuts
746-0778 (2) 712-0121 (2)
Hex Nuts
(_I _!2"30!0!2)
Flat Washers
736-0! 85 (2)
__ 7!4"0!04
ATTACHING CHUTE ASSEMBLY
Hex Bolts Hex Lock Nuts
716.3015 (2) 712-3027 (6)
i Ii IF
-!
=-=
Chute Flange Keepers
731-0851 (3) Not Shown
@ ©©
711-0677 Hairpin Clips Flat Washers
714-0104 (2) 7736.0275 (2)
E_ ATTACHING THE CLUTCH GRIPS
Hex Screws f'-_-"_ _
7!0,3103(2! ( _ 'ff ('-',,'_
idlH!lll! l! ll0"J
,--- 750.1032(2)
: : HexTop L-Nut
G REPLACEMENT SHEAR BOLTS
Hex Lock Nuts _7] F1
7!2-0429(2) _ Hex Bolts
71o-06goA,2)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. Ifyou hit a hard foreign
object or an ice jam, the snow thrower is desi ned so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed