Manual

Models 602, 642, and 662: Rotate the shift arm
assembly counter clockwise, as far as it will go.
Insert the shift rod through the shift arm assembly.
When installed the shift arm assembly should point
to the right. Secure with flat washer and hairpin clip.
See Figure 7.
Models 614, 644, 664 and 6A4: Rotate the shift
arm assembly counter clockwise as far as it willgo.
Insert the shift rod through the shift arm assembly.
When installed, the shift arm assembly should point
left. Secure with flat washer and hairpin clip. See
Figure 8. (Viewed from the operating position.)
_ Shift Hairpin /TrriaCti_ut ch
Auger" \_='_ _ _ J €
Drive Clutch _ 1
Ferrule
(B°tt°m Hole)"_1 _ :Washer
.oR\
_Wl" t' Hairpin
SAhjsftemArb_Y_ Ldj_ /clip
Models 602, 642 and 662
Figure 7
Models 602, 642, and 662: Thread the ferrule up
or down the shift rod and align with the lower hole
on the shift lever assembly behind the handle
panel. See Figure 7.
Models 614, 644, 664, and 6A4: Thread the ferrule
onto the shift rod, up or down the shift rod and align
with the far hole on the narrow side of the shift lever
assembly behind the handle panel. See Figure 8.
Secure the ferrule to the shift arm assembly with
the flat washer and hairpin clip.
NOTE: Make certain to check for correct adjustment
of the shift rod as instructed in the FINAL
ADJUSTMENTS section before operating the snow
thrower.
AttachingClutchCables(HardwareD)
Thread the hex jam nuts all the way up the
threaded portion of the "Z" ends.
Make certain all cables are in the grooves of the
cable roller guides. The roller guides are located in
the lower rear of the unit. Lift the clutch grip in the
raised (up) position.
Thread the cable onto the threaded portion of the
"Z" end until there is no slack in the cable, but the
cable is NOT tight. Do not overtighten cable.
See Figure 9.
When correct adjustment isreached, tighten the
hex nut against the cable to lock it in position.
WARNING: If cable is tightened so there
is tension on the cable with the clutch grip
released, the safety features of the snow
thrower may be overridden.
!_r_!!_ _'_FI....-_\_wather Shii Lever _ _ _Tiri_tCtceh°n
Models 614, 644, 664 and 6A4 _
Figure 8
Cable Should
Be Straight-- ---=
Figure 9
AttachingtheChuteAssembly(HardwareF)
Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit.
Place chute flange keepers beneath lip of chute
assembly with flat side down. See Figure 10.
Insert hex bolt up through chute flange keeper and
chute assembly. Secure with hex lock nut.