Manual

SafetyIgnitionKey
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove the ignition key
when the snow thrower is not in use. See Figure 14.
IMPORTANT: Do NOT "turn" the ignition key in an
attempt to start the engine. Doing so may cause it to
break.
Clean-OutTool
NOTE: This item is fastened with a cable tie to the rear
of the Auger Housing at the factory. Cut the cable tie
before operating the snow thrower.
WARNING: Never use your hand to
clear a clogged discharged chute. Shut off
engine and remain behind handles until
all moving parts have stopped before
unclogging.
The chute clean-out tool is fastened to the top of the
auger housing with a mounting clip. The tool is
designed to clear a clogged discharged chute. Refer to
OperatingYourSnowThrowersection for more detailed
information regarding the chute clean-out tool.
See Figure 14.
Discharge Chute
Shift Lever
\
Gas Fill
Oil Fill
Directional Control
Clean*Out
Primer
Rope
Key Thmttle
Contml
Skid Shoe
Figure 14
SECTION5: OPERATINGYOURSNOWTHROWER
BeforeStarting
WARNING: Read, understand, and
follow all instructions and warnings on
the machine and in this manual before
operating.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes an other sources
of ignition.
11