Operator`s manual

Assembly& Set-Up
3
Contentsof Carton
One Lawn Mower
One Lawn Mower Operator's Manual
One Grass Catcher
One Engine Operator's Manual
One Bottle of Oil
Assembly
NOTE:This unit is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual BEFORE operating your mower.
Handle
1.
Remove any packing material which may be between
upper and lower handles.
a. Pull up and back on upper handle as shown in Fig.
3-1. Make certain the lower handle is seated securely
into the handle mounting brackets. Do not crimp
cable while lifting the handle up.
Figure 34
b. Tighten star knobs securing upper handle to lower
handle. See Fig. 3-1. Make sure that each carriage
bolt is seated properly in the handle.
2.
Locate hairpin clip in one hole on the weld pin on each side
of lower handle.
a. Remove hairpin clip from this hole. Using a pair of
pliers, insert hairpin clip into the other hole on the
weld pin. Repeat on other side. See Fig. 3-2.
I Handle Hardware /
Carriage Bolts (2)
Wing Nuts (2)
Figure 3=2
J
b.
Insert a carriage bolt found in the manual bag into
the upper hole on the handle mounting bracket.
Secure with one plastic wing nut, also included in
the manual bag. See Fig. 3-2. Repeat on other side
with remaining hardware from manual bag.