Manual

6,
7,
Grasp starter handle and pull rope out slowly
until engine reaches start of compression cycle
(rope will pull slightly harder at this point). Let
the rope rewind slowly.
Pull rope with a rapid, continuous, full arm
stroke. Keep a firm grip on starter handle.
Return it slowly to the rope guide.
NOTE: If the engine fails to start after three (3)
pulls, push the primer two (2) times and pull starter
rope again.
Edging Position
2,
Figure 11
Set the adjustment lever (refer to Figure 8) in the
first or second notch at the top for beveling. See
Figure 12.
Figure 10
STOPPING THE ENGINE
To stopthe engine:
1. Release the blade control handle to stop the
engine.
2.
3.
If equipped with a throttle control lever on the
engine, set the lever to the SLOW (turtle)
position.
Disconnect spark plug wire and ground to
prevent accidental starting while equipment is
unattended.
OPERATING THE EDGER
_lb WARNING: Rotating cutting blade may
throw objects causing personal injury.
Keep area clear of bystanders and do not
operate without guards in place.
1. Set the adjustment lever (refer to Figure 8) in the
middle notch of the blade tilt control to edge
vertically. See Figure 11.
Beveling Position
3.
Figure 12
Set the adjustment lever (refer to Figure 8) in the
fourth or fifth notch at the bottom for trenching.
See Figure 13.
Trenching Position
7
Figure 13