Manual

Figure 7
BLADE TILT CONTROL
The cutting blade can be adjusted to five positions;
from beveling to edging to trenching. To adjust,
make sure the engine is not running. Release the
adjustment lever on the pivot bracket and pivot the
lever to the desired cutting position. Place the
adjustment lever in the notch desired. See Figure 9
Figure 8
PRIMER
The pdmer is used to pump gas into the carburetor.
Use it to start a cold engine, but do not use it to
restart a warm engine after short shutdown. Refer to
the engine manual. See Figure 7 and Figure 8.
Figure 9
Figure 10
CURB WHEEL CONTROL (Optional)
The right rear wheel can be adjusted to edge along
a curb. The forward handle position is for normal
edging operation. Pull the handle out and move
handle towards the rear of the unit to compensate
for the height of the curb. See Figure 10.
NOTE: Become familiar with all the controls and
adjustments before operating the edger so you can
adjust it easily to a vadety of edging conditions. DO
NOT ATrEMPT TO MAKE ANY ADJUSTMENTS
while the engine is running.