Manual

WHEELS
Lubricate the wheels and bearings at least once a
season with light oil or engine oil. Also if the wheels
are removed for any reason, lubricate the surface of
the axle bolt and the inner surface of the wheel with
light oil. See Figure 18.
PIVOT POINTS
Lubricate the pivot points on the blade control
handle, brake cable and the cutting height
adjustment lever with light oil at least once a
season. See Figure 18.
CUTTING HEAD BEARINGS
The two ball bearings in the cutting head are
lubricated and sealed at the factory and require no
lubrication. Lubricate all other moving parts with
engine oil.
SHAFT
Lubricate the two bearings and under the
compression spring on the shaft with light oil
frequently during the season. See Figure 19,
Note: isshown without support brace for clarity.
Lube Lube
Lube
Lube_
Lube
Left Rear
Wheel
Lul_
(Optional)
Lube
Figure 18
SECTION 9" MAINTENANCE
d_hb WARNING: Disconnect the spark
plug wire and ground against the
engine before performing any
adjustment, repairs or maintenance.
ENGINE
Refer to engine manual for complete instructions for
care and maintenance of engine.
BLADE REMOVAL AND INSTALLATION
Removal
1. Use a 15/16" box or socket wrench on the bolt
head under the belt guard and a 15/16" wrench
to remove the lock nut holding the blade. See
Figure 20.
Figure 19
Figure 20
2. Remove the blade and two bell washers. See
Figure 21.
11