Specifications

3 Set-Up
Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier.
See See Fig. 3-4.
\
" ! i!i
Figure 3-4
4. Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-5.
/
i,<
/ /'
/
o
Figure 3-5
ShearPins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower, Store them in your snow
thrower's dash panel until needed. See Fig. 3-6.
f
Figure 3-6
ChuteClean-OutT001
The chute clea n-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-7.
Chute Clean=out Tool
Figure 3-7
SECTION3 -- ASSEMBLY& SET-UP 7