User`s manual

Lake Shore MTD Series Cryotest System User’s Manual
Options, Accessories, & Cables 6-1
CHAPTER 6
OPTIONS AND ACCESSORIES
6.0 GENERAL
This chapter provides lists of MTD Cryotest System options and accessories. Options are detailed in
Paragraph 6.1. Accessories are detailed in Paragraph 6.2. Finally, a list of associated Lake Shore
Publications is provided in Paragraph 6.3.
6.1 MTD CRYOTEST SYSTEM OPTIONS
A list of major MTD Cryotest System Model numbers is provided below. The MTD Cryotest System can
be tailored to fit many custom applications. Therefore, there are many possible MTD configurations.
Please consult the factory for assistance in designing a new MTD for your application. Further
information on the Model 140 and 144 Pour-Fill Dewar is provided in Appendix F. A typical filter wheel
assembly is described in Appendix G.
MODEL DESCRIPTION OF SYSTEM OPTIONS
MTD-140
MTD-144
MTD-150
MTD-150B
MTD-154
MTD-158
Single-Position, Pour-Fill Dewar System.
Four-Position, LCC Pour-Fill Dewar System.
Original Single-Position, Continuous-Flow Cryostat System, with round fanout board.
New Single-Position, Continuous-Flow Cryostat System, with revised cold finger and
square fanout board (S/N 10182B and after).
Four-Position, Continuous-Flow Cryostat.
Eight-Position, Continuous-Flow Cryostat.
6.2 ACCESSORIES
Accessories are devices that perform a secondary duty as an aid or refinement to the primary unit. A list
of accessories available for the MTD System is as follows. A cross reference of accessory to MTD
System Model Number is provided in Table 6-1.
MODEL DESCRIPTION OF ACCESSORY
330-11
Model 330 Autotuning Temperature Controller. The Lake Shore Model 330 digital control unit
provides precise temperature measurement and stable temperature control for the test device(s)
over the full useful temperature range of the MTD Systems. The Model 330 features both
AutoTuning and manual PID temperature controlling modes, SoftCal™, dual sensor inputs,
RS-232C, and IEEE-488 Computer Interfaces. The Model 330-11 is recommended for use with
MTD Models 150, 154, and 158. Please consult the Lake Shore Product Catalog for
configuration, options, and accessory details.
330-11-W50
Model 330 Autotuning Temperature Controller with 50W Heater Output. Same as the Model
330-11 but with 50 watt heater output. The Model 330-11-W50 is recommended for use with the
MTD Models 140 and 144. Please consult the Lake Shore Product Catalog for configuration,
options, and accessory details.
1015
Warm-Up Power Supply. The Model 1015 provides up to 80 watts of heater power on each of
two channels to warm up both the first (cold finger) and second (radiation shield) stages of the
MTD System to room temperature for rapid sample turnaround. Independent temperature control
loops are provided for each channel so that each stage may be monitored and shut down
automatically when it reaches room temperature. Two different power supply levels are available
to each channel, supplying a low range of 25 watts or a high range of 80 watts into a 25 Ω load.
The Model 1015 is recommended for use with Models MTD-150, -154, and -158. Please consult
the Lake Shore Product Catalog for configuration, option, and accessory details.