Manual

SECTION2: ASSEMBLINGYOURTILLER
NOTE: This operator's manual covers various models
of riflers. The units illustrated may vary slightly from
your unit. Follow only those instructions which pertain
to your model number.
NOTE: References to right or left side of the tiller are
determined from behind the unit in the operating
position.
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
LoosePartsInCarton
Tailpiece and Depth Stake
NOTE: All hardware needed for assembly is attached
to the loose parts or the tiller.
BeforeAssembly
WARNING: Disconnect the spark plug wireand ground it against the engine to prevent
unintended starting.
AssemblingTheHandle
• Remove the handle adjustment lever from handle
and lift up upper handle to raise in operating
position. See Figure 1.
• Reinsert adjustment lever through the lower hole,
tightening the lever into lock nut on the retainer
bracket.
• Once the lever is in the lock nut, the handle can be
moved to the desired position and then tighten
securely.
Handle
Adjustment Lever
\
\
\
AttachingTailpieceandDepthStake
ToolsRequiredForAssembly
(1) 1/2" socket wrench (or adjustable wrench)
• Remove the two self-tapping screws on the frame
and slide the tailpiece into the frame, with the lower
hole in the tailpiece toward the front. See Figure 2.
• Secure tailpiece with the screws just removed.
Tailpiece
Figure 1
Self-Tapping
Screws
Handle
Adjustment Lever
-Retainer Bracket
Figure 2