Specifications

P25 Series of Engines

Module

Remove the ignition module:

1. Remove the starter by following the procedures

described in Chapter 6: starter.

2. Disconnect the red wire from the module.

See Figure 4.6.

NOTE: The black wire will come off with the module

mounting screws.

3. Remove the module by removing the two screws.

4. To install the module, turn the flywheel so that the

magnets are away from the module.

5. Install the two screws half way. Do not tighten them

down.

NOTE: Make sure the black wire is on the proper

mounting screw. See Figure 4.6.

6. Place a non-magnetic, 0.010” feeler gauge on the flywheel magnets and rotate the flywheel until the magnets

line up with the module. Let the magnets draw the module against the flywheel with the feeler gauge trapped

between them. See Figure 4.6.

NOTE: The air gap range is 0.010” - 0.015” (0.25 - 0.38mm).

7. Torque the module screws to 30 - 40 in lbs (3 - 5 Nm).

8. Reassemble the engine by following the above steps in reverse order.

9. Test run the engine in a safe area before returning it to service.

Figure 4.6

Black wire

on mounting screw

0.010” brass feeler gauge

Red wire

For Parts Call 606-678-9623 or 606-561-4983