Specifications

P25 Series of Engines

Testing the module

To test the module:

1. Remove the starter housing by following the proce-

dures described in Chapter 6: Starter.

2. Check the air gap for the module. Set it to 0.010” by

following the steps described in the module section

of this chapter. See Figure 4.3.

3. Disconnect the red wire.

4. Install the starter as described in the starter section

of this chapter.

5. Install the clutch as described in the clutch section

of this chapter.

6. Pull the starter rope with the spark tester still

hooked up to the spark plug wire.

• If there is spark now, test the engine stop switch

and check the red wire for a short to ground.

• If there still in no spark, hold a screwdriver against the magnets on the flywheel to feel if they are mag-

netic. If the magnets are good, replace the module. If not, replace the flywheel.

Figure 4.3

wire

Red wire

0.010” feeler gauge

For Parts Call 606-678-9623 or 606-561-4983