Specifications

iMPORTANT:Usea torque
wrenchto tightenthe
flange nut to between37
foot-lbs, and50 foot-lbs.
iMPORTANT:Make
certainthatthe drivebelt
is seatedcorrectlyonthe
bladespindleandthat
it is ridingsmoothlyon
the spindlesheavesand
is not pinchedbetween
them. Repeatthe first
threestepsif the beltis
pinched.
iMPORTANT:For best
results,proceedslowly
along the pathbeing
trenched,slowlymoving
the edgerbackand forth
throughthe cuttingarea.
Specifications are
subjectto changewithout
notification or obligation.
imagesmy not reflect
yourexactmodel and are
for referencepurposes
only.
Fiat
Tri-starBlade
Figure5-7:TheoptionalTri-starbladeandwasher.
iMPORTANT:Makecertainthat the drive beltis
seatedcorrectlyon the bladespindle and that it is
riding smootMy on the spindle sheaves and is not
pinchedbetween them. Repeatthe first three steps
if the belt is pinched.
.
Setthe beveladjustmentlever(referto Figure5-2)
inthe centernotchto placethe edgerbladeina
900position,Figure5-8, andplacethe bladedepth
controlleverinthe lowestposition.
IMPORTANT:For best results, proceedslowly
along the pathbeing trenched, slowly moving the
edger back and forth through the cutting area.
Edging Along A Curb
Theright,rearwheelofthe edgercanbeloweredintoone
of fivepositionsto easethetaskof edgingalonga curb.
Toadjustthe heightof the curbwheel,proceedas
follows:
1. Lowerthe right,rearwheelby movingthe curb height
adjustmentleverslightlyto the left, Figure5-9.
2. Pivotthe right,rearwheelintoanapplicableposition
inrelationto the heightof the curbto beedged
along.
3. Releasethe curb heightadjustmentleverto lockthe
wheelinposition.
NOTE:Several passesmaybe necessary to obtain
the desired depth of cut. Do not lower blade more
than one depth notch at a time.
Figure 5-8: Edging/TrenchingPosition.
ifCurb Height "_
Adjustment \
X
Lever
J
Figure5-9:UseCurbHeightAdjustmentLeverto adjustthecurb
wheelheight.
Figure5-10:Thewheelinthe loweredposition.
10