Manual

AttachingTheHopperAssembly(A,Models)
• Remove six hex nuts and washers from the weld
studs on the impeller housing. Leave the support
plate in place on the weld studs. See Figure 2.
• Place hopper assembly into position in front of
impeller housing, aligning holes in hopper
assembly collar with weld studs.
Impeller Housing
Bracket
He:aShe_
Hopper
Assembly
pper
Bracket
Release
Rod
Weld Stud
Figure 2
• Slide hopper assembly onto weld studs and replace
washers and hex nuts. Do not tighten completely.
• Lift hopper assembly up to impeller bracket
assembly and slide the release rod out slightly to
hook the hopper bracket onto the rod. See Figure 2.
• Tighten the six hex nuts that secure hopper
assembly to impeller housing and also tighten the
hex nuts that secure hopper bracket to hopper
assembly.
AttachingTheDischargeChute(A,Models)
• Remove the wing knobsfrom each side of the lower
impeller housing. See Figure 3.
Hex Lock Nut
Bolt
,Wing Knob
scharge Chute
Figure 3
• Remove the hex lock nut, spacers, and hex bolt
from the top of the impeller housing.
• Align the discharge chute in position on the
discharge opening and insert hex bolt with spacer
through hinge on discharge chute (spacers fit inside
of hinges). See Figure 3.
• Place second spacer over hex bolt inside other
hinge and secure with hex lock nut.
• Secure both sides of discharge chute to impeller
housing using wing knobs previously removed.
AttachingTheChipperChute
(Model463 Thru4650nly)
• Remove the three cupped washers and hex nuts
from weld studs besides the opening on the side of
the impeller housing. See Figure 4.
• Remove the hex bolts, lock nuts, and fiat washers
from the two holes on the upper end of the support
brace.
Weld Stud
Chipper
Chute.
Washer
Lock Nut
ppo_ Brace
Hex Nut
Cupped
Washer
Figure 4
• Align the chipper chute over the weld studs, so the
slot in the bottom of the chute is facing down.
• Secure chipper chute with the three cupped
washers (cupped side against the chipper chute)
and hex nuts previously removed. Do not tighten
the nuts at this time.
• The chipper shredder was shipped with one end of
the support brace already secured to the lower
frame. Loosen but do not remove the bolts securing
the brace to the frame.
• Align the holes in the chute with the holes in the top
of the brace and attach brace to chipper chute with
hardware previously removed. Tighten securely.
• Tighten the bolts securing the support brace to the
frame.
• Tighten the three nuts on the weld studs holding the
chipper chute to the impeller housing.
AttachingTheBag(A,Models)
• To attach the bag, place the opening of the bag
completely over the discharge chute.
• Depress the plunger on the drawstring and pull on
the drawstring untilthe bag is tight around chute
opening. Release plunger to lock itinto position.