Specifications

NOTE: DIMENSIONS ARE IN INCHES.
5
1
0.5c
I
,
PI
7
-
0
@=il
Figure 2-l. Clearance Requirements
c. Mounting Procedure.
1. Design and Manufacture Foundation. Foun-
dation must be able to withstand at least
1670 ft-lbs torque plus 900 lbs weight. Refer
to Figure 2-2 for footprint dimensions of
power positioner. Use this footprint as a
guide to design foundation to match base of
power positioner. Mounting holes in base are
drilled for 3/4 inch foundation bolts. Decide
which foundation material is best suited for
your application, steel or concrete, and
design and manufacture foundation.
2. I”stallatio”.
(a) Install power positioner on foundation
with 3/4 inch bolts and standard flat
washers.
(b) Make we power positioner is level.
Check by measuring side to side and
front to back with a level.
(c) If power positioner is not level, remove
314 inch bolts that seame power
positioner to foundation and install
shims between the power positioner
and foundation. Continue this process
until power positioner is level when
3/4 inch mounting bolts are tightened.
This will prevent distortion of power
positioner stand.
(d) If installed on a concrete foundation,
grout foundation with additional con-
crete to prevent distortion of power
positioner stand.
NOTE: DIMENSIONS ARE IN ,NCHES
0
-
71 I
I 7.00
I\\
’ c3
~
J
0
0
I
POOWS
Figure 2-2. Mounting Dimensions
IS-102-208
2.2