Specifications

166 Version 2.0
If Value is specified which should be typed in hex value, this command will write this
value to specified address. Otherwise when this command is executed, the current
contents of Address are displayed. If Value is specified, then –n is assumed.
If -n is not specified, the command will run in interactive mode and the user has the
option of modifying the contents by typing in a hex value. When the user pressed
‘ENTER’, then next address is displayed. This is continued until the user enters ‘q’.
Examples
To display or modify memory:
Address 0x1b07288, default width=1 byte:
fs0:\> mm 1b07288
MEM 0x0000000001B07288 : 0x6D >
MEM 0x0000000001B07289 : 0x6D >
MEM 0x0000000001B0728A : 0x61 > 80
MEM 0x0000000001B0728B : 0x70 > q
fs0:\> mm 1b07288
MEM 0x0000000001B07288 : 0x6D >
MEM 0x0000000001B07289 : 0x6D >
MEM 0x0000000001B0728A : 0x80 > *Modified
MEM 0x0000000001B0728B : 0x70 > q
To modify memory: Address 0x1b07288, width = 2 bytes:
Shell> mm 1b07288 -w 2
MEM 0x0000000001B07288 : 0x6D6D >
MEM 0x0000000001B0728A : 0x7061 > 55aa
MEM 0x0000000001B0728C : 0x358C > q
Shell> mm 1b07288 -w 2
MEM 0x0000000001B07288 : 0x6D6D >
MEM 0x0000000001B0728A : 0x55AA > *Modified
MEM 0x0000000001B0728C : 0x358C > q
To display IO space: Address 80h, width = 4 bytes:
Shell> mm 80 -w 4 -IO
IO 0x0000000000000080 : 0x000000FE >
IO 0x0000000000000084 : 0x00FF5E6D > q
To modify IO space using non-interactive mode:
Shell> mm 80 52 -w 1 -IO
Shell> mm 80 -w 1 -IO
IO 0x0000000000000080 : 0x52 > FE *Modified
IO 0x0000000000000081 : 0xFF >
IO 0x0000000000000082 : 0x00 >
IO 0x0000000000000083 : 0x00 >
IO 0x0000000000000084 : 0x6D >
IO 0x0000000000000085 : 0x5E >
IO 0x0000000000000086 : 0xFF >
IO 0x0000000000000087 : 0x00 > q
• To display PCI configuration space, ss=00, bb=00, dd=00, ff=00, rr=00: