Specifications

CONTROLS
IGNITION SWITCH
The ignition switch is located on the dashboard. The
engine is started by turning the key to the START
position. When the engine is running, leave the key in
the ON position. To stop the engine, turn the key to
the OFF position. See figure 7.
,_ WARNING: Remove the key from the
tractor when the tractor is not in use to
prevent accidental starting.
THROTTLE CONTROL
The throttle control is located on the dashboard and is
used to regulate the engine speed. To get maximum
efficiency from cutting, the throttle should be in the
FAST position when operating the mower. See figure
7.
Light Ignition
Switch_ Switch
Throttle
Lift
Ammeter
Clutch-Brake
Pedal
FIGURE 7.
CHOKECONTROL
The choke control is located on the dashboard and is
operated manually. Details for the choke operation
are covered in the separate engine manual packed
with your unit. See figure 7.
LIGHT SWITCH
The head lamps are operated by pushing the light
switch located on the dashboard. The head lamps will
only operate when the engine is running. See figure 7.
AMMETER
The ammeter registers the rate of battery charge or
discharge. The ammeter will register on the discharg-
ing side with starting the engine. It should register on
the opposite side (charging) when the engine is
running in the fast position until the battery is com-
pletely charged. With a fully charged battery or with
the engine idling, the ammeter will not show a charge.
See figure 7.
HYDROSTATIC CONTROLLEVER
The hydrostatic control lever is located on top of the
fender on the right side of the tractor. This single con-
trol lever, connected to the hydrostatic transmission,
controls both the speed and direction of the tractor.
Infinite speed control is achieved by moving the con-
trol lever forward or backward. The farther forward or
backward you move the control lever, the faster you
will travel. Pulling the control lever into neutral (N)
area will stop the tractor. See figure 8.
Hydrostatic /
Control _/
Lever
FIGURE 8.
CLUTCH-BRAKEPEDAL
The clutch-brake pedal is located on the left side of
the tractor. See figure 7. Depressing the pedal returns
the drive unit to neutral (N) and applies the brake.
NOTE: The clutch-brake pedal must be depressed to
start the engine.
PARKING BRAKE
To set the parking brake, depress the clutch-brake
pedal, pull up the parking brake knob and release the
clutch-brake pedal. It will stay in the raised position.
To release the parking brake, depress and release
the clutch-brake pedal. See figure 9.
NOTE: The parking brake must be set if the operator
leaves the seat with the engine running.
FIGURE 9.
7