Manual

• Ontheleftside,installthelockwasherandhexnut
andtightenfingertight.
• Ontherightside,insertthehexboltintothehex
holeinthecordinsulator.Installthelockwasher
andthreadthehexnutontothehexbolt.Make
certainthatthecurvedportionofthecordinsulator
isrestingflushagainsttheupperhandle.
• Tightenthehardwarefirmlyusinganadjustable
wrenchorsuitabletighteningtool.
• RefertoFigure3forproperalignmentofhardware
andhandles.
• Routethepowercordthroughthecordinsulatoron
therighthandleandpressit intothemolded-incord
keeperontherighthandsideofthedeckasshown
inFigure4.
Upper Handle
Cord Insulator
Hex Bolt/
Lower Handle
Power Cord
Power _
Cord_
ight Rear View _lolded-in
Cord Keeper
Figure 4
• Install wire clips and route the power cord through
them as shown in Figure 5.
Upper Handle
Cord Insulator
Wire'Clips
Cord
Lower Handle
Y
Figure 5
InstallingGuideRodandCordRestraint
The guide rod and cord restraint need to be installed on
the upper handle of the lawn mower. To install, see
Figure 6 and continue:
Upper Handle
Cord Restraint
Guide Rod
Figure 6
• Slide the cord restraint onto the guide rod through
the round hole as shown in Figure 6.
• Standing behind the unit, working on the left portion
of the upper handle, insert the Z-end of the guide
rod into the hole on the outer part of the upper
handle.
• With the left part of the guide rod inserted in the
upper handle, bring the other end of the guide rod
around the outside of the upper handle on the right
side, and insert the end into the hole on the inner
portion of the upper handle. Refer to Figure 6 for
proper mounting position.