Specifications

Chapter 6 Setting up parameters
- 113 -
6-7 Test mode
The test mode consists of required functions for system test, such as JOG operation functions,
operations of pseudo output signals, and I/O signal monitors.
The [test mode] indicates and operates the following items:
Mode Code Position mode Setting
Code
Speed mode Setting
Jo JOG operation Possible Jo JOG operation Possible
SP JOG speed SP JOG speed
Ac JOG acceleration
Possible
Ac JOG acceleration
Possible
InP Output port operation Possible InP Output port operation Possible
c I/O monitor Impossible c I/O monitor Impossible
An Analog monitor manual output Possible An Analog monitor manual output Possible
Test mode
So Speed command auto-offset Possible So Speed command auto-offset Possible
6-7-1 Operating in the test mode
● Selecting operations of function items
(1) To transfer to the [test mode] from the [monitor mode],
press the [SET] key at least three seconds.
⇒Transfers to [test mode] when there is no indication
on 4th to 6th digit.
(2) Press the [UP] or [DOWN] key to change the functional
items of the [test mode]
⇒ Every pressing the [UP] key shifts a code of the first
digit one by one from [Jo] to [So], and indicates a value
corresponding to the code.
⇒Every pressing the [DOWN] key shifts a code of the
first digit one by one from [So] to [Jo], and indicates a
value corresponding to the code.
● Function
(1) Transferring to the test mode:
1st to 3rd digit: indicates [TST].
4th to 6th digit: Indicates [-] throughout the transfer.
(2) For the test mode:
1st and 2nd digit: Codes in the mode
A D J
D O W N U P A D J S E T
D O W N U P S E T
Monitor mode
Press 3 sec.
Test mode
A D J D O W N U P S E T
Selecting a function
1st digit 6th digit