Manual

Placethesteeringwheelcapoverthecenterofthe
steeringwheelandseatitwithyourhand.
Steering
Wheel_ap
Hex Lock _
Cupped
__ Steering
Bellow
Screws
Manual Adjustment Seat
g
Shaft
Figure 1
AttachingTheSeat
There are two different seat pivot brackets used on this
series of lawn tractor, a manual adjustment seat or a
quick adjustment seat. See Figure 2 and 3 to identify
which seat is on your unit. Follow the instructions which
apply to your lawn tractor.
ManualAdjustmentSeat
Remove the four screws which secure the seat to the
seat pivot bracket. Turn the seat around and place in
position against the seat pivot bracket, lining up the
slotted holes in the pivot bracket with the holes in the
seat. Select desired position for the seat, and secure
with the four screws. See Figure 2.
NOTE: Your seat may have been shipped in a box.
Remove the four screws from the bottom of seat and
place seat in position against the seat pivot bracket.
Follow the directions above to attach the seat.
QuickAdjustmentSeat
Pull out tab on seat stop and hold open while sliding
seat out of seat pivot bracket. See Figure 3. Turn the
seat around and line up plastic seat spacers with the
slots in seat pivot bracket. Slide seat in until front seat
spacer engages the seat stop. See Figure 4. To adjust
the seat refer to the adjustment section in this manual.
NOTE: If your seat was shipped in a box, line up
plastic seat spacers with the slots in seat pivot bracket
and slide seat in until front seat spacer engages seat
stop.
A
WARNING: Before operating this machine,
make sure the seat is engaged in the seat
stop, stand behind the machine and pull back
on seat untiI fully engaged into stop.
Figure 2
Seat Pivot
Quick Adjustment Seat
Figure 3
Seat
S
Seat
Spacers
Quick Adjustment Seat
Figure 4