Specifications

Installation Details
% Saturation Calibration Accuracy: +3% RH
Temperature Calibration Accuracy: ±1°C
Thermal Stability: ±1% RH (over compensated temperature range +10 to +80°C)
Stability: ±0.2% RH typical at 50% RH in 1 year
Linearity: ±0.5% RH typical
Analog Output Hysteresis: ±0.5% RH Full Scale
Switched Output Hysteresis: 2% RH
Operating Temperature Range: -40°F to +185°F (-40°C to +85°C)
Operating Humidity Range: 5 to 100% RH (non condensing)
Response Time: 60 sec in slow moving air at 25°C
Maximum Rated Pressure: 6,000 PSI (420 Bar)
Maximum Torque: 22 ft-lbs
Seal Material (depending on MS): Fluorocarbon, EPDM, Per uoroelastomer
Material: Stainless Steel 303
Connector Details: M12x1, 8 Way, IP67 Connector (IP68 when mated with molded cable)
Maximum Cable Length: 33 ft (10 m) with Voltage Output, 330 ft (100 m) with current output
Output: SEE ORDERING INFORMATION
Pin Wire Colour Designation I/O Description
1 White Alarm Switch Output Alarm Switch.
Constant 5Vdc when in normal operation.
Switch to 0Vdc when in alarm condition.
Red LED illuminates when Sensor is in an alarm condition.
2 Brown Analogue Output Temperature - Degí Celsius.
User Select Output (0-3Vdc, 0-5Vdc, 1-6Vdc and 4-20mA).
3 Green Alarm Limit Output Alarm Limit (0-6V).
Output that directly corresponds to the alarm set point.
4 Yellow Analogue Output % Saturation.
User Select Output (0-3Vdc, 0-5Vdc, 1-6Vdc and 4-20mA).
5 Grey Receive Input RS232 Communication.
6 Pink Send Output RS232 Communication.
7 Blue Common Input Common (0Vdc).
Ground from power supply.
8 Red Supply Input Supply Voltage (+8 to +30Vdc).
Green LED illuminates when power is properly applied.
Moisture Sensor Wiring and Pin Designations
Pin 8
MS200 Moisture Sensor
Specifications
Ø1.97 (50mm)
.945 (24mm)
4.17-4.21 (106-107mm)
2.24 (57mm)
1.65 (42mm)
.157 (4mm)
Ø.472 (12mm)
Ø1.02 (26mm).0
.512 (13mm)
.394 (10mm)
.945 (24mm)
A/F
Hexagon
Thread detail
dice pattern
M12 x 1.0 pitch
54
Pin 2
Pin 1
M12, 8 Way Connector
Pin Details
dimensions in inch (mm)