Technical data

BT AND PT STORAGE TANKS

Storage tanks to be used in heating and cooling systems, to

ensure minimum heat pump operating time in all operating con-

ditions and avoid excessive starts and stops. It can also be

used to isolate the water circuit from the heat pump and to par-

tially meet energy demand during periods in which the unit is

shutdown due to the electricity rate. For indoor installation.

The diagram illustrates the use of the BT/TP storage tank as a

low-loss header to separate the heat pump primary circuit from

the secondary circuit to the terminal units.

This allows different flow-rates and temperatures to be managed

depending on the type of terminal used.

Correctly sized, it guarantees the minimum water volume

required by the heat pump.

The diagram illustrates the use of the BT/TP storage tank as a

storage tank on the heat pump return pipe so as to increase the

volume of water available in the system, avoiding excessive

starts and stops.

In this case, make sure the available pressure head of the

pump on the unit is sufficient to guarantee correct system oper-

ation.

Models available Volume

BT35 35 litres

BT100 100 litres

BT200 200 litres

TP300 300 litres

The diagram shown is purely indicative.

i-KI(R) MTD

HFC 410Ai-KI(R)_MTD_0011_0061_201307_EN