Specifications

19
TNT 100 VERTICAL ENGINES
25
26
BEND CONTROL
BRACKET TO SET
RPM
VERTICAL ENGINES
TVS 115 ENGINE WITH DUAL
SYSTEM CARBURETOR
BEND TO INCREASE SPEED
BEND TO DECREASE SPEED
HIGH SPEED RPM
ADJUSTMENT
SCREW
GOVERNED / NON-GOVERNED IDLE
With the engine running at its lowest speed, set the governed idle at the designated R.P.M. by bending the
idle R.P.M. tab. Next set the non-governed idle by pushing the bottom of the governor lever away from the
control brackets, so the throttle lever contacts the idle speed screw. Hold the lever in this position and turn
the idle adjustment screw clockwise to increase or counterclockwise to decrease engine idle speed. The
setting on the carburetor screw should be set at 600 R.P.M. below the governed idle setting. This setting
prevents the throttle plate from closing when going from high speed R.P.M. to low speed R.P.M. If improperly
adjusted, the engine could experience an over lean condition.
VERTICAL SHAFT ENGINES
28
BEND TO INCREASE SPEED
BEND TO DECREASE SPEED
27
HIGH SPEED
RPM
ADJUSTMENT
SCREW
IDLE SPEED
CRACK SCREW
NOTE:
ON REMOTE CONTROL
THIS WILL NOT BE
PRESENT
LOW SPEED ADJUST
HIGH SPEED ADJUST
OVRM
29
Engine Speed and Mixture Adjustments - continued
3-5 H.P. Vertical Shaft Engines
LOW SPEED TAB
HIGH SPEED TAB
DECREASE
INCREASE
HIGH SPEED
PIN POSITION
TOOL
(670326)
SNAP IN CONTROL
24