Technical data

SightLine Applications Command and Control

5 AutoFocus Metric Region Size % of screen (0 to 100)

6 Zoom Track Focus (0= disabled, 1= enabled)

7 Autofocus method (0=scan far to near, 1=seek)

8 Autofocus Rate Adjust (0 to 255) 100 = default speed of motion

Autofocus Change Percent (0 to 255) in 1/10ths of a percent. 40 (default) =

Set Digital Camera Parameters (0x70)

Set parameters that pertain to a specific digital camera. ROI (Region Of Interest) for autogain statistics

is used to indicate a part of image to be used in calculations. This is defined as an offset from the

relevant edge as a percentage of the full width/height of image.

Note: setting both “Autogain Max value” and “Autogain Min Value” to 0 will result in these parameters

being ignored.

Byte

offset

Description

2 Packet length = 12

3 Packet type = 0x70 NEW: 2.19

4 Camera Id of digital camera (SLA1500 = 2)

5 Mode (1 = freeze Autogain at min/max below)

6,7 Autogain Max value (max value maps to 255 in 8 bit output)

8,9 Autogain Min Value (min value maps to 0 in 8 bit output)

Row ROI for Autogain stats. Row Offset in % of image height (255=100%)

Full image (default) = 0

Col ROI for Autogain stats. Col Offset in % of image width (255=100%)

Full image (default) = 0

High ROI for Autogain stats. Height in % of image height (255=100%)

Full image (default) = 255

Wide ROI for Autogain stats. Width in % of image width (255=100%)

Full image (default) = 255

Current Digital Camera Parameters (0x71)

Get current parameters that pertain to the currently selected digital camera. This is sent as a response to

a Get Parameters Function (0x28) (CurrentDigCamParams) request.

Byte Description