Technical data

SightLine Applications Command and Control

4 – 5

System Type

Bit Functionality

Analyze - System will perform image processing and

will produce telemetry

1 Render - System will perform rendering/display

2 Deprecated NEW 2.20

3 – 15 Reserved

Set Packet Destination (0x64)

Used to configure the output destination for TELEMETRY. See Set Coordinate Reporting Mode

(0x0B) for the types of telemetry output that are available.

Byte offset Description

2 Packet length = 4

3 Packet type = 0x64 NEW: 2.18

Function

Value Description

0 Unknown or Not Defined

1 ADD -Add this IP address as telemetry output

destination

2 DELETE - Remove this IP address from receiving

telemetry output

3 DELETE ALL - Remove all IP address from

telemetry output list

4 – 15 Reserved

Camera ID - Results from this hardware are reported as

cameraID in the Tracking Position (0x43) and Current Tracking

Positions (0x51). Receiver can then apply these results to the

local camera of the same ID. (Defaults to 0xFF internally to

indicate value has not been set.)

6 – 9 IP Address – IP address of the receiver

10 – 11

Destination Port – data will be sent to this port on the receiver

(default: 14001)

12 – 13 Reserved NEW 2.19