Technical data

SightLine Applications Command and Control

Set Stitch Parameters (0x2B)

Set the parameters for image stitching mode. Requires Set Video Mode (0x1F) be used to set number

of camera inputs to 2, display to Network Mode.

Byte offset Description

2 Packet length = 10

3 Packet type = 0x2B

4 Reserved = 0

5 Shift camera one up. (0 … 255) number of pixels

6 Shift camera one right. (0 … 255) number of pixels

7 Shift camera one down. (0 … 255) number of pixels

8 Shift camera one left. (0 … 255) number of pixels

9 Reserved = 0

10 Reserved = 0

11 Reset calibration. (1 = = reset, 0 = = don't)

Two raw images Right Images is shifted

relative to the left

The maximum overlap is

calculated

Final image is displayed

in a 1280x480 window

Set Moving Target Indication Parameters (0x2D)

Set the parameters for Moving Target Indication (MTI). Results in Current Tracking Positions (0x51)

results being generated. See also Set Coordinate Reporting Mode (0x0B).

Four modes of automatic moving target indication are available, depending on the security bits enabled.

1. Vehicle Medium Moving Target Indication. This mode works best when finding moving

vehicles in a moving scene. It works well from a moving aerial platform for finding vehicles

that are typically 10 to 100 pixels long in the scene. It does not work as well at finding very

small, very large, slow or erratically moving objects.

2. Staring Small Moving Target Indication. This mode works well when the camera is either

stationary or moves then stares for extended times at a scene. It can find objects that are small

and move at slow, fast or varying rates or that temporarily stop.

3. Full Mobile Small Moving Target Indication. This mode works from a moving platform and

can find small and slow or fast or erratically moving objects. It is capable of handling scene

motion that with significant perspective change. It will lose objects that stop moving. This