Technical data

SightLine Applications Command and Control

Get Version (0x00)

Get Parameters Function (0x28) Version (0x00)

Reset (0x01)

Allow user to reset different aspects of the system.

Byte offset Description

2 Packet length = 3

3 Packet type = 0x01

Reset Type:

Value Description

0 parameters only reset to factory defaults

1 video decoder

2 board soft reset (reboot board with saved defaults)

3 Stop application (SLA-1500-ONLY)

4 Deletes any saved parameter files and soft resets the

board NEW 2.17

5 Send reset command to any known camera attached

(TAU, Sony, etc) NEW 2.18

6 Soft parameter only reset to factory defaults (does not

reset network, serial port or camera type settings)

NEW 2.18

7 – 255 Reserved

Set Stabilization Parameters (0x02)

Turn on or turn off stabilization and control re-centering rate for output video. Video stabilization

smooths out jumpy sequences caused by camera vibration. Default value is “on” with re-centering rate

= 50. A low number (approaching 0) = a slow drift to center. A high number (approaching 255) = a fast

drift to center (see note below). Maximum stabilization limit is used to set an upper bound on the time-

averaged stabilization solution.

NOTE: Bit 3 of the Mode field in the Current Stabilization Parameters (0x41) packet indicates the state

of the Auto-Bias algorithm. See Set Stabilization Bias (0x12) for more information on enabling Auto-

Bias.

Byte Offset Description

2 Packet length = 6