Technical data

SightLine Applications Command and Control

Checksum Calculation Example:

Data Description Action CRC

0x51 Header 1 Ignored 0x01

0xAC Header 2 Ignored 0x01

0x02 Length Ignored 0x01

0x07 Type Used 0x01 ^ 0x07 = 0x06

Look up result Table[6] = 221 (0xDD)

Table 5: Example Checksum Calculation

CRC should equal 221.

Serial Port

Serial port parameters are configured:

Baud 57600

Data Bits 8

Stop Bits 1

Parity None

Handshake None

Table 6: Default Serial Port Configuration

See Serial Port Parameters for additional baud rates supported.

• You can set the serial port properties of the unit explicitly using the Configure Communication

Port (0x3E) command.

• Refer the specific hardware ICD to determine if serial port is 3.3VTTL or RS-232C level

signals.

Ethernet

Command and control is also available over Ethernet.

All commands can be sent as a UDP packet to the IP Address of the system on port 14001. All replies

will be sent to the IP address of the sender on port 14002. The ports can be changed using Set Network

Parameters (0x1C).