Installation Guide

Vessel/Over-Mount Installation
2
For the recommended Pop-up Installation, please see diagram below. We strongly recommend hiring a licensed
plumber to properly install the drain & water connections. The diagram will specify the process & parts needed for
installation. Due to a large variety of plumbing applications & city and state codes, we do not provide plumbing
parts such as P-Trap and other components apart from the pop-up drain(s). Your item may appear slightly different
from the illustration. These componets can be purchased at any local hardware store.
Please note: If your counter top arrived with pre-assembled sink please skip to Step 7.
1. Safely remove the packaging from your counter
top and place on a flat surface facing down. If your
counter top is made of marble/natural stone, make
sure to place it on an evenly flat surface to avoid and
movements.
2. Remove the double sided tape strip that is located on
top of the base cabinet. Li the counter top in a vertical
position, & then carefully place the counter on top of the
cabinet. It is best to align your counter top with your cabi-
net base from back to front. We recommend acquiring
help to li &place counter top to avoid any potential
breakage that may occur during installation. Damages in-
curred during the installation process are not covered
under warranty.
3. Place vessel sink over the predrilled drain hole.
4. If necessary, you can use a clear/white silicon sealant aer plumbing has
been connected to apply around the sink/s to secure it in place. The sealant
is not included in the box and can be purchased at any local hardware
store. Please refer to the below steps before finalizing this step.
Installation Guide
Page 4
Pop-Up Drain & P-Trap Installation