User manual

Operating manual – Chipper Shredder with electric motor English
9
Problem Possible cause Remedy
Engine does not start. Connection cable not connected
or defective.
Check and plug in cable; if required replace
or have it repaired by a specialist
Household fuse overloaded. Switch on fuse; if required increase the fused
house connection or have one installed
by a specialist
On/Off switch defective. Have it repaired by a specialist company
Extension cable too long or cross
section too small.
Extension cable min. 1.5 mm², max. 25 m long.
In the case of longer cable cross section
min. 2.5 mm².
Overload protection has switched
off.
Before restarting the unit, wait at least one
minute before you first press the reset button (3)
and then the On switch (4a).
Motor is humming,
but not running.
Cutter deck blocked. Change direction of rotation of the cutter deck,
then switch off and clean the unit.
Faulty capacitor. Have it repaired by a specialist company
Material to be chopped
up is not pulled in.
Cutter deck is rotating in wrong
direction.
Adjust direction of rotation.
Material to be chopped is jammed
in the feed hopper.
Change direction of rotation of the cutter deck,
then switch off and clean the unit.
Material to be chopped up is too
soft or wet.
Push in with a branch and chop up.
Wear on the cutting roller. Adjust cutter deck.
Material to be chopped
up is not severed
cleanly.
Wear on the cutting roller or
cutting roller not set correctly.
Adjust cutter deck.
Strong vibrations. Damaged blade shaft or defective
cutting roller.
Switch off the unit immediately.
Have defective parts replaced by a specialist
workshop.