User manual

Operation
12
EN
Operation
CAUTION!
Injuries or material damage.
¾ Note the mains voltage.
¾ The voltage of the current
source must match
the information on the
identication plate of the
device.
Note
The power pack becomes hot
during operation.
Charging A
Î Plug the charger into a suitable
socket A1.
3 The LED goes red.
Î Plug the power pack into the
charger A2.
3 Charging starts and the LED goes
green.
Note
2 AH battery
The power pack is 80% charged
after about 50 minutes and fully
charged after about 70 minutes.
4 AH battery
The power pack is 80% charged
after about 100 minutes and fully
charged after about 140 minutes.
LED charge state indicator on the
charger
LED status Meaning
Steady red
Mains voltage con-
nected.
Flashes green Charging.
Steady green Charging completed.
Flashes red-green
Power pack possibly
defective. Arrange for
testing of the power
pack by a specialist
workshop.
Flashes red
Power pack too hot or
too cold. Charging starts
automatically if the
operating temperature is
correct.
Steady red
Power pack is not
charging. Power pack is
not correctly inserted or
the contacts are dirty.
Note
To protect the power pack and
ensure a long service life, the
charger switches off as soon as
the power pack is fully charged.
Note
¾ Do not store the power pack in the
charger, but separately from it.
Troubleshooting information
WARNING!
Risk of injuries or material damage.
¾ Pull out the mains plug.
¾ Do not open the device.
¾ In case of doubt always consult a specialist workshop.