Replacement Part List

CLEAN OUT TOOL
Part # / Parte #
931-2643 / 731-2643
MTD, LLC
P.O. Box 368022
Cleveland, OH 44136
Made in U.S.A
CAUTION:
Never use your hand to clear a clogged discharge chute.
Shut off the engine and remain behind handles until all
moving parts have stopped before unclogging.
Mounting Instructions
(Blower Housing):
1. Measure the width of the housing
and locate the center.
2. Line up the center of the housing
with the centerline shown on
the template.
3. Use a center punch to mark the
location of the mounting holes.
4. Drill two 1/8-inch pilot holes at the
center of the punch locations.
5. Drill two 11/32-inch holes at the
pilot hole locations. NOTE: Remove
any burrs from drilled holes.
6. Install mounting bracket into
holes and cut tie wrap.
NOTE: Make sure snaps are rmly
snapped in place.
CENTER LINE
EJE LONGITUDINA
L
TEMPLATE PLANTILLA
TEMPLATE
PLANTILLA
CENTER LINE eje LoNgITudINAL
NOTA: VER LAS INSTRUCCIONES
DE MONTAJE AL REVERSO.
• The Safe And Easy Way To Clean
Snow And Ice From Snow Thrower
Discharge Chutes
HERRAMIENTA PARA LIMPIEZA
• La manera mas segura y facil de
limpiar la nieve y el hielo de los tubos
descargadores del barredoras de nieve
CLEAN OUT TOOL
645-80331 OEM-731-2643