Warranty

Lift Adjustment
If the lift index rod doesn’t securely latch or the pivot release has
too much slack in it, an adjustment can be made as follows:
1. Loosen the upper hex nut a few turns, then tighten the
lower hex nut to shorten the cable length. See Figure 3-24.
2. Loosen the lower hex nut a few turns, then tighten the
upper hex nut to lengthen the cable. See Figure 3-24.
Hex Nuts
Figure 3-24
Lower Chute Crank Support Bracket Adjustment
If the spiral at the base of the lower chute crank isn’t fully
engaging with the notches in the lower chute assembly, the
support bracket can be adjusted inward or outward as follows:
1. Loosen, but do NOT remove the two hex nuts which secure
the support bracket to the snow thrower housing.
See Figure 3-25.
Figure 3-25
2. Adjust the support bracket inward or outward so that the
spiral is fully engaged in the notches on the chute before
retightening the hex nuts.
13Section 3 — ASSembly & Set-Up