Warranty

Attaching The Chute Directional Control
1. Attach the chute directional control assembly to the upper
lift link on the left side of the auger housing. Assemble with
two hex screws and two saddle washers as shown in Figure
3-15. Secure with two flange nuts.
Figure 3-15
2. Secure the upper chute crank rod (A) to the joint block on
the lower chute crank rod with the cotter pin (B) provided.
See Figure 3-16.
A
B
Figure 3-16
3. Fasten chute tilt cables to chute directional control with
two of the cable ties provided. Pull cable ties until snug and
trim excess.
Attaching The Lift Handle
1. Attach lift handle to lift bracket on the right side of auger
housing assembly with two hex screws and two flange nuts
provided. See Figure 3-17.
Figure 3-17
2. Fasten the lift cable to the lift handle with two of the cable
ties provided. Pull the cable ties until snug and trim excess.
Mounting The Auger Assembly
IMPORTANT: It will be necessary to have a second person assist
you to complete the following steps.
1. Install a shoulder bolt (found in the hardware pack) on each
side of the tractor’s front end and secure with a lock nut.
See Figure 3-18.
Figure 3-18
10 Section 3— ASSembly & Set-Up