Manual

7
115 A
115 B
115: Standing on the North Side of the array with the Tube to Angle bolts started but not ghtened,
sight the Angle pieces to ensure they are parallel. If not, twist the array unl they are then ghten the
bolts between the Rectangular Tubes and the Angle.
116 B
116 A
116 C
116: Plan the layout of your rails according to your module width. Install the Beam Clamps on the I-beam
using the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts.
Remember to leave a 7-8” gap in the center to allow for the 6” diameter pipe to protrude through, if you
wish to put all the modules on at ground level.