Manual

7
115 A
115 B
Standard Beam Clamps Long Beam Clamps for Rails >168”
115: Standing on the North Side of the array with the Tube to Beam bolts started but not ghtened,
sight the beams to ensure they are parallel. If not, twist the array unl they are. .
116 A
116: Plan the layout of your rails according to your module manufacturer’s recommendaon. Install the
Beam Clamps on the I-beam using the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts. Tighten to 20 
lbs. The TOP-15 uses a long angle-shaped clamp to give extra support to the span and canlever. Aach
angle using the square plates provided and the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts.
For the 8-TOP-8, remember to leave a 9-10” gap in the center to allow for the 8 5/8” (OD) pipe to protrude
through, if you wish to put all the modules on at ground level.
*For standard array conguraons using 60 cell modules (approximately 40” x 65”), see pg 11.
Then ghten all the 3/4” bolts between the Pipe and Rectangular Tubes and the Tubes and the I-Beams
to 100  lbs.
116 B