Manual

7
116 A
116 B
Standard Beam Clamps OR Long Beam Clamps for 204” Rails
116: Standing on the North Side of the array with the Tube to Beam bolts started but not ghtened,
sight the beams to ensure they are parallel. If not, twist the array unl they are. Then ghten all the
3/4” bolts between the Pipe and Rectangular Tubes and the Tubes and the I-Beams to 100  lbs.
117 A
117: Plan the layout of your rails according to your module manufacturer’s recommendaon. Install the
Beam Clamps on the I-beam using the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts. Tighten to 20 
lbs. Mounts with 204 inch rails require a 4 . long angle-shaped clamp to give extra support to the span
and canlever. Aach angle using the square plates provided and the 3/8” x 1 1/4” carriage bolts and 3/8”
ange nuts.
*For standard single pole array conguraons, see last page.
117 B