Operation Manual

33
“To set answer on or off press 7”.
“To hear the outgoing message menu press 8”.
“To set a new security code press 9”.
“To hear main menu again press 1”.
When the last message is played “End of messages” will be heard.
11.2 Set the security PIN code
Using the handset:
1. Press Menu, scroll Down to « TAM SETTINGS » and press Menu.
2. Scroll Down to « REMOTE CODE » and press Menu. The handset will display
the current code.
3. Enter a new code and then press Menu to confirm.
11.3 Check security code
1. Press Del at the base. The security code is announced.
12. Help
No dial tone
. Use only the telephone line cord supplied.
. Check that the telephone line cord is connected properly.
. Check that the mains power is connected properly and switched on.
No display
. Check that the batteries are inserted correctly and fully charged. Use only
approved rechargeable batteries supplied.
. Check that the handset is switched on. Press and hold End Call.
. Reset the base by removing the batteries and disconnecting the mains power.
Wait for around 15 seconds before connecting it again. Allow up to one minute
for the handset and base to synchronize.
icon flashes
. Handset is out of range. Move closer to the base.
. Make sure that the handset is registered to the base, see page 26.
. Check that the mains power is connected properly and switched on.
Keypad does not seem to work
. Check that the keypad lock is not on, see page 17.