Operation Manual

TROUBLE SHOOTING
Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer.
Symptom Cause Solution
No power.
The car ignition switch is not on.
The fuse is blown.
If the power supply is connected to the car accessory circuits, but the
engine is not moving, switch the ignition key to “ACC”.
Replace the fuse.
Disc cannot be loaded or ejected.
Presence of CD disc inside the player.
Inserting the disc in reverse direction.
Compact disc is extremely dirty or defective disc.
Temperature inside the car is too high.
Condensation.
Remove the disc in the player, then put a new one.
Insert the compact disc with the label facing upward.
Clean the disc or try to play a new one.
Cool off or until the ambient temperature return to normal.
Leave the player off for an hour or so, then try again.
No sound.
Volume is in minimum
Wiring is not properly connected.
Adjust volume to a desired level.
Check wiring connection.
Sound skips.
The installation angle is more than 30 degree.
The disc is extremely dirty or defective disc.
Adjust the installation angle less than 30 degree.
Clean the compact disc, then try to play a new one.
The operation keys do not work.
The built-in microcomputer is not operating
properly due to noise.
Press the RESET button.
Front panel is not properly fix into its place.
The radio does not Work. The radio
station automatic selection does
not work.
The antenna cable is not connected.
The signals are too weak.
Insert the antenna cable firmly.
Select a station manually.
EN
Instruction Manual