Operation Manual

MODE SELECTION
• Shortly press MOD/
button to select the desired mode, such as Radio, CD
(MP3), USB, Card, AUX mode.
• When there isn’t an USB or memory card connected to the unit, the
corresponding mode will be skipped.
• For Bluetooth function, when pairing successful, you can select BT or A2DP
(Bluetooth audio) mode through MOD/
button.
ESP FUNCTION
• The unit can be shockproof about ten seconds.
REMOTE SENSOR
• Point the remote control handset to the remote sensor. Press the function keys
on the handset to control the system.
AUXILIARY INPUT
• The unit can be connected to a portable audio player through the AUX IN jack
on the front panel. After finishing the connection, you can press MOD button on
the front panel to switch the mode to AUX IN mode.
RADIO OPERATION
SELECTING THE FREQUENCY BAND
• At radio mode, press BAND button shortly to select the desired band.
• The reception band will change in the following order:
> FM1 > FM2 > FM3 > AM (MW) >
SELECTING STATION
• Shortly press
/ buttons to activate automatic seek function. Press for several
seconds until “MANUAL” appears on the display, the manual tuning mode is
selected. If both buttons have not been pressed for several seconds, they will
return to seek tuning mode and “AUTO” appears on the display then disappears.
AUTOMATIC MEMORY STORING & PROGRAM SCANNING
• Automatic memory storing: Press AS/PS button for several seconds “SEARCH”
will appear on LCD. the radio will search from the current frequency and checks
the signal strength until one cycle search is finished. And then 6 strongest
stations are stored into the corresponding preset number button.
• Program scanning: Press AS/PS button shortly to scan preset station. And the
corresponding station number P1~P6 will flash on LCD.
MONO/STEREO
• Press AF/MON button for several seconds to select mono or stereo mode.
You can sometimes improve reception of distant stations by selection mono
operation.
SCAN
• Press SCAN button to enter scan mode, the unit will scan to higher frequency
station and keep on each station for several seconds.
STATION STORING
• Press any one of the preset buttons (1 to 6) to select a station, which had been
stored in the memory. Press this button for several seconds to store the current
station into the number button.
RDS (RADIO DATA SYSTEM) OPERATION
• Setting RDS mode: Press AF/MON button to switch on or off RDS mode.
• USE PTY BUTTON: Press PTY button will enter PTY SELECT mode, the program
name will be displayed on the LCD, you can use
/ buttons to select the
items and press
/ buttons to begin search the corresponding program.
Instruction Manual