Operation Manual

DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these mounting instructions.
• Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio mounting brackets supplied with
your vehicle.
Side view showing screw holes
marked T, N
Fa
ctory radio
mounting bracke
t
Screw
Screw
Dashboard or console
• To fasten the unit to the factory radio mounting brackets.
• Align the screw holes on the bracket with the screw holes on the unit, and then
tighten the screws (5x5mm) on each side.
• Note: the outer trim ring, sleeve and the metal strap are not used for method
B installation.
USING THE DETACHABLE FRONT PANEL
• Press the release ( ) button, then the front panel will be folded down.
• To remove the front panel, lift it up at a little angle from horizontal position, then
first pull out the right side and then pull out the left side. Note: not completely
horizontal
Left side
Front panel
Right side
• For safekeeping, store the front panel in the supplied protective case
immediately after being removed.
Instruction Manual